Audio-Technica M3 Wireless In-Ear Monitor SystemAudio-Technica M3 Wireless In-Ear Monitor System

Audio-Technica M3 Wireless In-Ear Monitor System
Item Code
:
HATMPM3
Price
:
$799.00
Extended Warranty
:
Quantity
:
  • Overview
  • Feedback

Wireless M3T stereo transmitter with headphone output, M3R stereo receiver with 3.5 mm line-in jack and EP3 in-ear dynamic headphones with 3 sizes of rubber earpieces plus ear-conforming foam tips.

Audio-Technica’s advanced M3 IEM system offers a full range of professional in-ear monitoring features, with a choice of 1321 UHF channels and easy-to-read LCD information displays on both transmitter and receiver for setting preferences. The stereo monitor system is equipped with Audio-Technica’s versatile Personal Mix Control, which allows volume and mix control of two independent signals on stage, via controls on the M3R stereo body-pack receiver. While up to 16 complete M3 systems may be used simultaneously, any number of M3R stereo receivers can operate on the same frequency with a single M3T stereo transmitter. The M3T Stereo Transmitter is equipped with two XLR/¼” combo input connectors into which users can connect line-level inputs (from a mixing console, for example). The M3T also offers a headphone output that allows you to monitor transmitter input signals directly.

Features:

  • High-fidelity sound with clean, articulate mix allows performers to hear themselves clearly at lower volume
  • 1321 selectable UHF channels with automatic frequency scanning
  • Up to 16 simultaneous systems per frequency band
  • Three receiver modes: Personal Mix, stereo, and mono
  • Personal Mix Control allows volume and mix control of two independent signals at the receiver
  • LCD information display offers step-through menus for setting preferences
  • XLR loop output (true pass-through) connects signal to mixing console, additional IEM system or recording device with no signal degradation
  • Adjustable squelch eliminates annoying static
  • Pilot tone protects against RF interference when transmitter is turned off
  • Multi-level limiter (defeatable) helps protect hearing from sudden peaks
  • Portable system is quick to load and set up
  • Reduces on-stage audio clutter for better overall mix & less feedback
  • Use any number of Stereo Receivers (with individual mixes) on the same frequency
  • Audio-Technica earphones with proprietary dynamic drivers offer full frequency response and outstanding isolation
  • Personal fit with 3 sizes of rubber eartips plus ear-conforming foam tips
  • Selectable auxiliary input offers connection point for ambient microphone, click track, or other mic- or line-level input

Specifications:

VERALL SYSTEM SPECIFICATIONS
Operating Frequencies Band E: 790.000 to 822.000 MHz, 1281 frequencies 
Band F: 832.000 to 865.000 MHz, 1282 frequencies 
Band L: 575.000 to 608.000 MHz, 1321 frequencies 
Band M: 614.000 to 647.000 MHz, 1321 frequencies 
Not all frequency bands available in all areas. Please check with local regulations.
Minimum Frequency Step 25 kHz
Modulation Mode FM stereo
Maximum Deviation ±40 kHz
Dynamic Range 90 dB (typical), A-weighted
Total Harmonic Distortion <1% at (1 kHz, ±20 kHz Deviation)
Operating Range 100 m (300'), typical 
(Open range environment with no interfering signals.)
Operating Temperature Range -5° C (23° F) to +50° C (122° F) 
(Battery performance may be reduced at very low temperatures.)
Frequency Response 60 Hz to 13 kHz (+/- 3 dB)
Simultaneous Use 16 channels per band (maximum recommended) 
For assistance with multi-band operation or other frequency coordination issues, please contact you regional Audio-Technica customer service representative.


RECEIVER SPECIFICATIONS
Receiving System Double conversion superheterodyne
RF Sensitivity 20 dBuV (at 60 dB S/N ratio, 50 ohms termination)
Headphone Output Connector 3.5 mm TRS stereo phone jack
Headphone Output Power 65 mW (at 32 ohms)
Antenna Input SMA-type, 50 ohms
Aux Input Connector 3.5 mm TRS stereo phone jack
Batteries 2 x 1.5V AA (not included)
Battery Life 8 hours (alkaline) 
Depending on battery type and use pattern
Dimensions 70.0 mm (2.76") W x 
25.0 mm (0.98") D x 
110.0 mm (4.33") H
Net Weight 133 g (4.7 oz), without batteries
Accessories Included EP3 earphone; flexible antenna


TRANSMITTER SPECIFICATIONS
RF Power Output 10 mW/50 mW (switchable), 50 ohms 
Limited to 10 mW within 863 MHz to 865 MHz 
Following national regulations
Spurious Emissions Following federal and national regulations
Input Connections XLRF-type/6.3 mm stereo (1/4") combination connector 
Pin 1 and Sleeve: Ground 
Pin 2 and Tip: Hot 
Pin 3 and Ring: Cold
Maximum Input Level XLRF-type/6.3 mm stereo, (1/4") balanced: +26 dBu 
6.3 mm (1/4") mono, unbalanced: +26 dBu
Loop Output Connector XLRM-type connector 
Pin 1: Ground 
Pin 2: Hot 
Pin 3: Cold
Power Requirement 12-18V DC, 600 mA
Headphone Output Connector 6.3 mm (1/4") TRS stereo phone jack
Headphone Output Power 120 mW at 32 ohms
Antenna Connector BNC, 50 ohms
Dimensions 210.0 mm (8.30") W x 
132.0 mm (5.20") D x 
44.0 mm (1.70") H
Net Weight 930 g (32.8 oz), without accessories




Download Instruction Manual

Would you like to help others by submitting a review? Create an account and earn points for your reviews!
 

We carry your favorite brands

Acesonic
AKG
ADJ
Audio-Technica
AxcessAbles
BMB
Crown
Enter-Tech Magic Mic
Gator
Hosa
JBL
Samson
Shure
Singing Machine
Soundcraft
VocoPro
Yamaha